Mercury Boot Log 2.6.18

Uncompressing Linux................................................................................ done, booting the kernel.
Linux version 2.6.18_pro500-davinci_evm-arm_v5t_le (jcw@gen9300) (gcc version 4.2.0 (MontaVista 4.2.0-16.0.32.0801914 2008-08-30)) #1 PREEMPT Sat Aug 15 21:40:06 EDT 2009
CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177
Machine: DaVinci EVM
Memory policy: ECC disabled, Data cache writeback
DaVinci DM6443 variant 0x1
CPU0: D VIVT write-back cache
CPU0: I cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets
CPU0: D cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets
Built 1 zonelists.  Total pages: 29696
Kernel command line: console=ttyS0,115200n8 ip=none mem=116M root=/dev/mtdblock2 rw rootfstype=yaffs2 lpj=741376 video=davincifb:vid0=720x576x16,2500K:vid1=720x576x16,2500K:osd0=720x576x16,2025K davinci_enc_mngr.ch0_output=COMPOSITE davinci_enc_mngr.ch0_mode=nc
PID hash table entries: 512 (order: 9, 2048 bytes)
Clock event device timer0_0 configured with caps set: 03
Console: colour dummy device 80x30
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 116MB = 116MB total
Memory: 115072KB available (2181K code, 208K data, 136K init)
Calibrating delay loop (skipped)... 148.27 BogoMIPS preset
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
DaVinci: 71 gpio irqs
WARNING: both NAND and NOR flash are enabled, but share pins.
        Disable NAND for NOR support.
ch0 default output "COMPOSITE", mode "NTSC"
ch1 default output "", mode ""
MUX: initialized LOEEN
MUX: initialized LFLDEN
VPBE Encoder Initialized
LogicPD encoder initialized
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 4096 bind 2048)
TCP reno registered
davinci_spi_board_init: NO spi support
Enabling VLYNQ clock
MUX: initialized VLINQEN
MUX: initialized VLINQWD
yaffs Aug 15 2009 21:41:47 Installing. 
io scheduler noop registered
io scheduler anticipatory registered (default)
davincifb davincifb: dm_osd0_fb: Initial window configuration is invalid.
Console: switching to colour frame buffer device 90x36
davincifb davincifb: dm_osd0_fb: 720x576x16@0,0 with framebuffer size 2025KB
davincifb davincifb: dm_vid0_fb: Initial window configuration is invalid.
davincifb davincifb: dm_vid0_fb: 720x576x16@0,0 with framebuffer size 2500KB
davincifb davincifb: dm_osd1_fb: 720x480x4@0,0 with framebuffer size 675KB
davincifb davincifb: dm_vid1_fb: Initial window configuration is invalid.
davincifb davincifb: dm_vid1_fb: 720x576x16@0,0 with framebuffer size 2500KB
davincifb davincifb.0: dm_osd0_fb: Failed to obtain ownership of OSD window.
DAVINCI-WDT: DaVinci Watchdog Timer: heartbeat 60 sec
Serial: 8250/16550 driver $Revision: 1.90 $ 3 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO map 0x1c20000 mem 0xfec20000 (irq = 40) is a 16550A
serial8250.0: ttyS1 at MMIO map 0x1c20400 mem 0xfec20400 (irq = 41) is a 16550A
serial8250.0: ttyS2 at MMIO map 0x1c20800 mem 0xfec20800 (irq = 42) is a 16550A
Linux video capture interface: v2.00
i2c /dev entries driver
physmap platform flash device: 01000000 at 02000000
physmap-flash physmap-flash.0: Could not reserve memory region
physmap-flash: probe of physmap-flash.0 failed with error -12
nand_davinci nand_davinci.0: Using 1-bit hardware ECC
NAND device: Manufacturer ID: 0x2c, Chip ID: 0xac (Micron NAND 512MiB 1,8V 8-bit)
Scanning device for bad blocks
Bad eraseblock 1397 at 0x0aea0000
Bad eraseblock 1561 at 0x0c320000
Bad eraseblock 1726 at 0x0d7c0000
Creating 4 MTD partitions on "nand_davinci.0":
0x00000000-0x00400000 : "bootloader"
0x00400000-0x00600000 : "kernel"
0x00600000-0x00e00000 : "rootfs"
0x00e00000-0x20000000 : "filesystem"
nand_davinci nand_davinci.0: hardware revision: 2.1
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
musb_hdrc: version 6.0, cppi-dma, host, debug=0
musb_hdrc musb_hdrc: No DMA interrupt line
musb_hdrc: USB Host mode controller at c7804000 using DMA, IRQ 12
musb_hdrc musb_hdrc: MUSB HDRC host driver
musb_hdrc musb_hdrc: new USB bus registered, assigned bus number 1
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
Advanced Linux Sound Architecture Driver Version 1.0.12rc1 (Thu Jun 22 13:55:50 2006 UTC).
ASoC version 0.13.1
MUX: initialized MCBSP
AIC3X Audio Codec 0.1
ALSA device list:
  No soundcards found.
TCP bic registered
NET: Registered protocol family 1
yaffs: dev is 32505858 name is "mtdblock2"
yaffs: Attempting MTD mount on 31.2, "mtdblock2"
Time: timer0_1 clocksource has been installed.
Clock event device timer0_0 configured with caps set: 08
Switched to high resolution mode on CPU 0
usb 1-1: new high speed USB device using musb_hdrc and address 2
usb 1-1: configuration #1 chosen from 1 choice
scsi0 : SCSI emulation for USB Mass Storage devices
Freechunks verification failure 1026 1090 -64
VFS: Mounted root (yaffs2 filesystem).
Freeing init memory: 136K
0
Starting the hotplug events dispatcher: udevd.
Synthesizing the initial hotplug events...done.
Waiting for /dev to be fully populated...done.
0
Mounting local filesystems: mount 
Please press Enter to activate this console.   Vendor: USB 2.0   Model: Flash Disk        Rev: 0.00
  Type:   Direct-Access                      ANSI SCSI revision: 02
SCSI device sda: 7897087 512-byte hdwr sectors (4043 MB)
sda: Write Protect is off
sda: assuming drive cache: write through
SCSI device sda: 7897087 512-byte hdwr sectors (4043 MB)
sda: Write Protect is off
sda: assuming drive cache: write through
 sda: sda1
sd 0:0:0:0: Attached scsi removable disk sda
sd 0:0:0:0: Attached scsi generic sg0 type 0